Skip To Content

Industrial Table Fabrication

Industrial Table Fabrication

Industrial Table Fabrication

A good customer of ours asked that we fabricate a heavy-duty steel table to accommodate an engine and pump combination. The engine powers an industrial-sized auger used to mix asphalt during the manufacturing process. The motor takes a large amount of torque once activated so a heavy-duty table to provide support and reinforcement is necessary.

The table is made from 7/8″ thick Grade A572 steel and is six feet by 10 feet. The framework is fabricated from 6″ x 6″ x 3/4″ angle iron with reinforcements designed throughout the under carriage.

Below are some pictures during the fabrication stage and once the table is set in its location at the manufacturing facility.

Leave a Reply

Your email address will not be published. Required fields are marked *

Ready to Start Your Next Project?

Contact Us